Questions tagged [security]
The security tag has no usage guidance.
112
questions
0
votes
0
answers
136
views
How can a designer be sure to authorize only legit ICs? How is performed? How are cloned ICs prevented to be activated?
The above diagram is from the IC Activation (locking/unlocking) slide of Fighting against theft, cloning and counterfeiting of integrated circuits by Lilian Bossuet Associate Professor, CNRS Chaire of ...
1
vote
3
answers
134
views
Switch ELECTRICALLY SAFE between 3 resistive loads (16 A each) on a 16 A line
How to switch 3 resistive consumers (heaters), each having a current consumption of nearly 16 A alternate & ELECTRICALLY SAFELY (German standards)?
So that only one of them heats at a time and the ...
0
votes
0
answers
35
views
BLE relay to control my garage door - security concerns
I would like to use Shelly 1PM Mini Gen3 to control my garage door. Since I do not have WiFi coverage in my garage I will rely on Bluetooth. However with this setup I am not sure if this Smart home ...
3
votes
3
answers
2k
views
How can I make an alarm circuit which senses both cutting and shorting the wire?
I have searched Google top to bottom the only circuit which fullfills my requirements is a wire break or wire loop security alarm as shown in figure 1. I soon realised that if the robber shorts the ...
-1
votes
1
answer
270
views
Reliable sensing method for device inside a parcel to detect when/if the parcel is opened?
I'm wracking my brain for reliable ways for an electronic device to detect when/if the parcel it is sealed inside is opened.
The device will be sealed inside the package and activated via Bluetooth ...
5
votes
3
answers
2k
views
ESP32 and security
I'm wondering how secured an ESP32 is.
I'd like to use one to read data on a Telnet device which should remain in an offline network for security purposes.
The ESP32 uses an Ethernet connection to ...
25
votes
5
answers
7k
views
Why are SRAM based FPGA used more than NVM based FPGA?
SRAM based FPGAs need to load the bitstream again after power off. Meanwhile the Non-Volatile based one don't need that.
I wonder, why are more experiments and security research done on the SRAM ...
0
votes
1
answer
101
views
Is there a (legal) wireless transmission solution for my underground parkade anti-theft alarm?
I live on the 4th floor of a low-rise condo building with a concrete parkade beneath. We have a serious problem with bicycle theft -- someone is coming in late at night with an angle grinder, and ...
0
votes
2
answers
54
views
Best way to use Driveay alert output (Open Collector NPN)
I'm learning as I go on this project.
I have a beam-break driveway alert that I would like to get the output from on a device like an Arduino or Raspberry Pi and need some guidance on the best ...
0
votes
0
answers
62
views
how to determine what chip wire allows BIOS flashing?
how to determine what chip wire/leg allows BIOS flashing?
I want to modify my MOBO to deny BIOS flashing.
I only want it allowed when I really need to write on it.
So, I need to know:
if it is ...
0
votes
0
answers
63
views
How safe is it to plug a resistor on a 12 V transformer?
I was thinking about using an old fridge as a seedling cabinet. I am tempted to use the resistor of an out of order pizza oven plugged on a small 12 V transformer to heat the cabinet.
I didn't do the ...
1
vote
2
answers
608
views
Blow MSP430 security fuse with FET430 or MSP-FETFlash programmer
Is it possible to use a FET430, MSP-FETFlash or similar programmer to program and then blow the security fuse of the MSP430 devices?
We have 500 which already been soldered on the boards and were ...
2
votes
1
answer
1k
views
Interfacing to end-of-line resistor in security system
Off-the-shelf security consoles utilize an end-of-line resistor to monitor the integrity of the cable runs, usually a 2 kΩ resistor.
Is there a more or less standard interface circuit that most of ...
1
vote
1
answer
164
views
Securing PCB from illegal redistribution [closed]
I'm wondering if there is a state of the art method for securing a PCB with a microcontroller against copy and illegal distribution.
For example the well known the flight controller SP racing F3 had ...
2
votes
3
answers
558
views
SRM32H743 signed DFU updates
I want to implement signed software updates to my MCU. It is connected via USB and I am using the USB DFU to upload a firmware to it.
I want only signed firmware to be allowed to be uploaded to the ...