![]() |
|
![]() |
Home | Reviews | Speed Test | Tools | News | Forums | Info | About | Join |
This FAQ is for setting up a BellSouth supplied Westell 2100/2200/6100 modem (Models A90-210030-04, B90-220030-04 and B90-610030-06/C90-610030-06, respectively) with a D-Link DSL router. Although actual screen shots vary throughout the DLink line, the instructions below are applicable to all models. Important Note: These procedures and pictures are based on the most recent firmware for the Westell. Other Westell firmware menus and screenshots are slightly different but the bridge options and functions are still available. It is highly recommended that you click here and update your Westell firmware. This FAQ has 3 Major sections: Section 1 - Overview Section 2 - Westell modem configuration Section 3 - D-Link router configuration information Section 4 - Connections and power up ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Verify that your NIC card is set to "Obtain IP Address Automatically". Completely power down the Westell and the computer(s). Power up the modem and press the reset button on the back of the modem. After the modem has fully initialized connect the Westell to the NIC and then power up the computer. ![]() Open a browser session and enter 192.168.1.254 in the URL address field to access the Westell interface. If you are unable to access the interface make sure your NIC is set to "Obtain an IP address automatically". This may require you to reboot the computer (or release/renew) to obtain a proper IP. ![]() Click on Broadband DSL Line from the top menu. Click on Configure Connection from the right menu. Select "Bridged Ethernet" from the Protocol pull down. Click on Save and restart the connection at the bottom. This will automatically restart the modem and the interface will return after the changes are saved. Note: functions like NAT, DHCP, IP Passthrough, and username and password will be disabled or irrelevant and can not be selected. After the modem has restarted, power down both the computer and the modem then physically disconnect the Westell. ![]() After the PC is powered down connect one of the router LAN ports to the computer NIC and power up the router and then the computer. ![]() Use the following steps to configure your D-Link DI-604 Router. Important Note: You must use the username@bellsouth.net format for your username. If you do not add "@bellsouth.net" after your username you will be unable to connect to the internet. ![]() ![]() ![]() ![]() Power everything down and physically connect the Westell, the router, and any computer(s). ![]() Westell 2100 shown. Pictures by Andy Houtz ![]() Power up the network equipment in this order: •Westell Modem (wait till the Ready light is a steady green) •D-Link Router •Computer(s) Open a browser session and go surfing! ![]() •You should check your tweak settings to optimize your new network. Reminder: If you are required to change your MTU, make sure that it is identical on all equipment (PCs and routers) in the network. For more information about changing MTU on a D-Link please click here. •The 6100 has an "Internet" light that is green whenever there is an active PPPoE session initiated by the Westell. Since you are using the DLink to establish the PPPoE session the light will stay off. This is normal. Andy Houtz Feedback received on this FAQ entry:
![]() by Andy Houtz |