All Questions
Tagged with aqueous-solution electrochemistry
71
questions
4
votes
1
answer
95
views
Why is my Ni or Fe cathode blackening and pores getting blocked during alkaline (6 M KOH) electrolysis?
I am conducting an electrolysis process for hydrogen $(\ce{H2})$ and oxygen $(\ce{O2})$ generation using a $\pu{6 M}$ $\ce{KOH}$ alkaline solution.
During the process, I have observed that my cathode ...
3
votes
1
answer
55
views
Experiment on pH vs Rate of Electrolysis - what do the results actually say?
My experimental setup looks at using different pH solutions (of $\ce{H2SO4}$ and $\ce{NaOH}$) for electrolysis of water with a Hoffman setup and then measuring the rate of production of gas (note this ...
13
votes
3
answers
2k
views
Do electrons really hang around the electrode while ions go take a swim?
This answer to this post addresses "what happens if you dip a single zinc electrode into some electrolyte solution." It explains that
However, though the zinc ion can diffuse through the ...
1
vote
0
answers
43
views
Increasing energy density for flow batteries with water based electrolyte?
Given a flow battery with a water based electrolyte, would it be possible to increase the energy density of battery by precipitating the redox active species from the anolyte and catholyte solutions? ...
4
votes
1
answer
578
views
Possible technique for measuring pH in solutions
I would like to develop a device that measures pH in aqueous solutions. I'm not a chemist, but I have some basic knowledge about electrochemistry. So, I thought I could use two electrodes quite close ...
0
votes
0
answers
65
views
Can we add specific conductivities at any concentration?
Suppose we have specific conductivities of $\pu{0.1 M}$ $\ce{K+}$ and $\pu{0.1 M}$ $\ce{Cl-}$. Can we add their specific conductivities to get specific conductivity of $\pu{0.1 M}$ $\ce{KCl}$?
4
votes
1
answer
234
views
How does a silver chloride electrode (Ag/AgCl) convert the potential in aqueous solution to the wire?
I am aware of the redox chemistry that happens at the electrode surface, but I'm not sure how exactly a change in electrical potential in the solution would change the potential in the electrode?
0
votes
1
answer
50
views
Passing protons through cation-permeable membranes
Protons are attached to a water molecule (making hydronium) in acidic solutions. If a container was split through the middle with a cation-permeable but anion impermeable membrane and, say, HCl was ...
1
vote
0
answers
49
views
How the optical fibre pH microsensors work?
Just browsed through the chemical sensor products of the company, called PreSens (https://www.presens.de/products/ph/sensors) in order to look for a precise method to measure pH change in a ...
4
votes
1
answer
366
views
Variation of conductance of saturated aqueous solution with temperature
The following question was asked in JEE Mains 2020:
Let $C_{\ce{NaCl}}$ and $C_{\ce{BaSO4}}$ be the conductances (in S) measured for saturated aqueous solutions of $\ce{NaCl}$ and $\ce{BaSO4}$, ...
2
votes
0
answers
109
views
Gouy-Chapman model
Recently I have been investigating the problem of a neutral solutions (with equal number of anions and cations) interacting with an infinite surface $z=0$ with electrostatic potential $\phi(z=0)=\...
3
votes
2
answers
477
views
Why is my battery of galvanic cells not enough to power a lamp rated for a lower voltage than the battery provides?
I made a series of 12 galvanic cells with saltwater as an electrolyte and zinc and copper as electrodes. It produces 8.8 V, but it can't even light a 2.5 V bulb (the bulb can be lit by a 1.5 V source)....
1
vote
1
answer
86
views
Incompatibility of Helmholtz Double Layer and Redox electrochemistry
In an electric double layer capacitor(EDLC) (or any situation with a Helmholtz double layer) what prevents the ions from being reduced or oxidized like the ions in an electrochemical cell?
If it is ...
-1
votes
2
answers
188
views
Recovery of Urea from aqueous solution [closed]
When adding Urea to water, the reaction is highly endothermic. I was playing with the idea of using that for a Desktop cooling system, but for that, I'd of course have to recover that Urea from the ...
1
vote
1
answer
168
views
what happens to the electrons in low-voltage conductivity of salt water [closed]
Suppose you take a 100 millivolt voltage source, and connect it using a pair of copper wires to a bath of salt water.
A current will flow through the water. If I'm not getting things completely wrong, ...