Questions tagged [electrolytic-capacitor]
An energy-dense polarized capacitor type, used in low-frequency filtering applications.
372
questions
0
votes
1
answer
28
views
Multiple smaller capacitors on power rail for NeoPixel / WS2812B strip
I read in the AdaFruit guide that a 500-1000uF capacitor is recommended on the power rail.
However, electrolytic capacitors in this capacitance are quite large. Depending on the length of the strip, ...
0
votes
1
answer
68
views
Cyclic Voltammetry for a Capacitor - Positive Current, Potential is decreasing?
In the boxed red region, why is the potential decreasing when the current is still positive? To my understanding, when the current is still positive (i.e. not changing direction), the capacitor will ...
1
vote
1
answer
129
views
Why conductor having charge(let say 1C) have tremendous potential but same conductor used in capacitor have low voltage?
When we talk about electrolytic capacitors or the supercapacitors (EDLC), then we know that we can store large amount of charges in it.
Since in electrolytic capacitors the aluminum plate acts as ...
1
vote
1
answer
182
views
How does temperature affect ripple current parameter in electrolytic capacitors?
A maximum ripple current declared, for example, at 100 kHz and at a temperature of +105 ℃ for an electrolytic capacitor, if estimated at a temperature of +85 °C, how much does it increase? What order ...
1
vote
2
answers
92
views
Decoupling capacitors for operational amplifiers
when in the refence design of an amplifier (for example OPA856) we see the + sign in a capacitor schematic, does this necessarily means we should use electrolytic capacitors?
If there is no positive ...
-3
votes
3
answers
120
views
Blowing up capacitors with a 9v battery [closed]
Hello, I have a 9V battery I would like to blow up some capacitors with; currently I have 6.3v 180uF capacitors that don't seem to blow up at least in a good time(I'm aiming for <5 seconds), they ...
18
votes
3
answers
4k
views
How to Measure Very Large Capacitance e.g. Super/Ultra Capacitors
I have recently acquired a couple of mysterious ultra/super capacitors from my brother. Apparently he doesn't remember any of the specifications or even brand... To further complicate matters, they ...
1
vote
1
answer
635
views
Two polarized electrolytic capacitors in series VS two bipolars in parallel
I need one bipolar 4.7uF 50v electrolytic capacitor. I have polarized 10uf 50v capacitors and bipolar 2.2uF 50v capacitors. I can place two of the 10uF in series (negative leads joined) or two of ...
1
vote
1
answer
366
views
THAT4315 audio analyzer - capacitors getting hot
I have designed a audio spectrum analyzer circuit with THAT4315 and a drivers for IN-13 bar graph nixie tube to visualize the signal level.
To supply +-12V to the opamps, the Meanwell NSD15 module is ...
0
votes
0
answers
21
views
Lithium Ion Battery : Electrolytic Capacitor At Buck Converter Output
It is recommended not to parallel electrolytic capacitors with a battery due to the leakage current of the electrolytic capacitor (which is small but worthy of consideration over large time periods) ...
1
vote
1
answer
87
views
Electrolytic 3-lead capacitor
I have a 3-lead capacitor that I'm having a hard time identifying. It is from an old Lafayette PF-30 receiver. I don't have schematics or a manual.
It has a high squeal when turned on, and my first ...
1
vote
1
answer
56
views
Possibillity of reverse polarity of Aluminum Electrolytic Capacitor
Introduction
First of all, this question more like theorical rather than practical as I want to test my understanding about Aluminum Electrolytic Capacitor, which I will later called Al-Cap for short.
...
0
votes
1
answer
57
views
Power schematic questions
I received a guitar pedal in poor condition and looking to repair. Checking through the schematic, it appeared the electrolytic caps were installed backwards. All other picture I could find online ...
2
votes
1
answer
296
views
How to identify surface mount electrolytic capacitors?
Various surface mount electrolytic capacitors seem to have no consistent marking method. Here are some examples:
(Image sources: 1, 2, 3)
How can I identify what value and voltage rating these are?
2
votes
1
answer
4k
views
Surface mounted electrolytic capacitor markings
Is this 22 µF / 16V? General rule of thumb for these markings?