I have a Dragino-Yun v2.4-shield, which is a device that can be connected with an Arduino to give it networking-capabilities. It has An Ethernet-Port and Wifi. I don't have a wifi-antenna at the moment so i tried connecting to it via the Ethernet-Port.
According to the manual, the address 172.31.255.254
is assigned to the Ethernet-Port in a /4
subnet (DNS-mask: 255.255.255.252
). I started with a blank Arch-Linux-ISO on a ThinkPad and got it so far, as to pinging the device was succesfull. According to the manual it should also be possible to connect via ssh
, but that didn't work.
I then rebooted and wanted to ran the commands cleanly, but didn't have any success on the second try. Here are the commands i ran, following this Archwiki-page (enp0s25
is the ethernet-link of my ThinkPad):
$ systemctl stop dhcpcd
$ ip link set enp0s25 up # It is up by default though
$ ip addr add 172.31.255.253/4 dev enp0s25
$ ip route add default via 172.31.255.252
$ ping 172.31.255.254 -c3
PING 172.31.255.254 (172.31.255.254) 56(84) bytes of data.
FROM 172.31.255.253 icmp_seq=1 Destination Host Unreachable
FROM 172.31.255.253 icmp_seq=2 Destination Host Unreachable
FROM 172.31.255.253 icmp_seq=3 Destination Host Unreachable
--- 172.31.255.254 ping statistics ---
3 packets transmitted, 0 received, +3 errors, 100% packet loss, time 4054ms
pipe 3
I will add, that i have very little networking-experience. Where am i wrong? Is there something i've missed?