I'm trying to cascade my network to get better wireless reception in my room and more LAN ports for more devices.
The first/primary router (CH7486E Wireless Voice Gateway) is located in the apartment living room and was supplied by my ISP (Comhem AB) and it is connected into the wall with a special cable to get access to their network (they provide internet, telephone land line and television). This is a wireless router and provides internet access to mine and my room mate's devices. I also have a cable drawn from it to my workstation (without WiFi).
Now I want to connect that cable in to a second router (D-Link DIR-655) and then connect the workstation to that 2nd router, as well as my second computer and a NAS, and my Xbox, and I want to use it wirelessly to connect my laptop to it as well (the primary router is so far away that the WiFi signal is rather low).
The 1st router has IP 192.168.0.1 and UPnP enabled (not sure if it matters) This router also acts as a DHCP Server with Starting Local Address: 192.168.0.2 Operation Mode is set to Routing (NAT on)
There are also some WAN Settings in this router that I don't know how to change, and I don't know if they need to be entered in the second router or so. Not sure if it is a security risk to post them here, so I censor them somewhat.
IPv4 Address: 83.248.xx.xx
IPv4 Default Gateway: 83.248.x.x
IPv4 DNS Servers: 83.255.xxx.xx and 193.150.xxx.xxx
If I type the Default Gateway into a browser it's not leading anywhere. Isn't the Default Gateway usually 255.255.255.0?
The 2nd router has IP 192.168.0.2 and both UPnP and DHCP Server is disabled. There is no connection type called "bridge" in this router so I just left it as is, and the DNS settings are left as is as well, set to dynamic. Should they be set to the same ones as noted from the 1st router above or something?
From my workstation I can get access to both routers via their IP adresses, so the routers seems to be communicating with each other, but I can't get access to the internet. In Windows (Windows 10) I have set it to get a dynamic IP.
I've tried PING and TRACERT to google via IP but without success.
tracert 173.194.222.113
Request timed out.
Transmit error: code 1231.
ping 173.194.222.113
PING: transmit failed. General failure.
The inner network seems to be working, I can share files between my devices regardless of witch router the device is connected to, but I don't get internet access from the second router, regardless whether I connect to it via cable or wireless.
My problem is I can't figure out where the problem is:
- Is it settings in Windows that's the problem?
- Is the 2nd router not "taking" internet access from the first router, or...
- Is the 1st router not "giving" internet access to the second router?