After extruding one time or subdividing the curve, if I try to extrude again, I get a figure 8 loop. I've used bezier curves before, but this is the first time in 2.9. Anyone know how to work around this?
1 Answer
$\begingroup$
$\endgroup$
2
This type of extrusion actually splits this control point and adds a new one in the middle.
It's not obvious that it happens since they are in the same location.
-
$\begingroup$ Wooowwww I didn't know what you meant at first, but after clicking around I see it. WTH? Maybe I'm just a noob, but I don't think that's not very intuitive. $\endgroup$ Commented Feb 6, 2021 at 1:46
-
1$\begingroup$ if you want a branch I think you can duplicate a control point and right click to send it back to original position, then you can extrude it basically starting a new curve $\endgroup$ Commented Feb 7, 2021 at 8:44