In the image below I would like only the light that passes through the sphere, in this case the bright dot in the center, to be visible. Is there a way to set this up in cycles?
Thanks, Tyler
3
-
5$\begingroup$ The bright light in your image is caused by Caustics but unfortunately there is no easy way (that I'm aware of) to render just the caustics from the image - and they are switched on/off via the Render properties so are not configurable via Scene or Render Layer. The only method I know that would allow you to do this would be to render the image once with Caustics enabled and again with Caustics disabled - then use the compositor to subtract the non-caustic image from the one with caustics, resulting in just the caustics left behind. If this sounds like a viable solution I can write an answer. $\endgroup$– Rich SedmanCommented Jun 29, 2018 at 11:26
-
$\begingroup$ For caustics you would be better off not using cycles, but luxrender. $\endgroup$– user1853Commented Jan 14, 2020 at 19:14
-
$\begingroup$ Or you can try Yafaray $\endgroup$– user1853Commented Jan 14, 2020 at 19:23
Add a comment
|
1 Answer
$\begingroup$
$\endgroup$
See this .blend file. I used nodes with the Transmission Depth node and two emission shaders joined with a mix shader. Set the green one to 0 strength and it should have the desired effect. I'll post a screen shot of the node set up in a moment. (The node set up for the lamp. It's a point source directly above the glass sphere.)
Here is the node set up.
The green is what will go away. The pink it what will be rendered.
Green disabled (strength is set to 0).
