All Questions
9
questions
1
vote
1
answer
125
views
Burning sound from the PSU
I am trying to make a bench power supply from an old 350W PC PSU
that provides 4 lines
3.3V 8A
5V 9A
12V 11A
-12V 1.5A
Here is the connections diagram:
I used this step down module to be able the ...
1
vote
0
answers
105
views
The best way to step down 12V to 5V with at least 10A current from a PS3 power supply for a WS2812B LED strip
I am new to electronics. I had a PS3 Super Slim power supply lying around, which outputs 12V up to 13 amps. Recently, I bought a 5-meter strip of WS2812B LED strip, which needs 5V, and the recommended ...
0
votes
0
answers
59
views
Reduce voltage ripple in wall power supply and buck converters
For my project I choose a wall AC/DC power supply (AEJ160PS12) with output voltage at 12V and intend to use some buck converters to step down from 12V to 6V and 3.3V. The chosed buck converters is ...
-1
votes
1
answer
143
views
Buck converter load voltage drop
I'm creating a buck converter from a NE555 and LM358 (feedback loop) for powering a tablet motherboard. (This is a learning experience for me, don't want to use an off-the-shelf board.)
Here is the ...
1
vote
2
answers
322
views
Do I need to include overhead when picking a power supply?
I need to power 40 Raspberry Pis, each requiring a 5V input and have a maximum current draw is 2.5A.
This would mean:
5 x 2.5 = 12.5W
12.5W x 40 = 500W
That I ...
1
vote
1
answer
524
views
Buck Converter design, which is better? 48V->12V direct conversion or 48V->24V->12V conversion for 12V application
I am designing a 1KW DC-DC buck converter with Vin(51V battery pack with Vnom = 48V) for driving four 250W motors. Is it advisable to step down the voltage directly from 48V to 12V or should I first ...
3
votes
2
answers
199
views
One step-down regulator 24 V to 1V or two step-down regulators with lower steps?
I am trying to design a working principle scheme to step-down the input voltage from 24Vdc ---> different low voltages (1.8 V, 1 V, 1.5 V, 3.3 V with ripples ~ 1%).
Could you kindly explain me the ...
0
votes
1
answer
107
views
Correct power supply for my project
I am making an autonomous bot where i need to power a few sensors (IR, PIR, sonic,etc) and an arduino. In total the sensors draw about 300 mA current(max).
My power supply is a LIPO of 12 V (11.1 V),...
0
votes
1
answer
2k
views
Need circuit for 12 volt 2 Amp step down power supply from 18 volt 1.5 Amp Input
I have a power supply which outputs 18v 1.5 amp. For the purpose of my project, I need a 12v 2 amp power supply. I was wondering, if I can make a simple buck converter to convert 18v 1.5amp DC to 12v ...