I am learning electronics as a hobby. Today, I was using the multimeter to learn current, voltage and resistance in a simple circuit.
I setup the breadboard with these parts:
- Small solderless breadboard
- 470 Ω, 1⁄4 W resistor
- Red LED, 5 mm
- 9 V battery snap connector
- 9 V battery
- Short length of jumper wire (1" or less)
I can read voltage in the circuit perfect but with current the readings on the multimeter is 0.0 when using the 10A port (LED turn ON) and with the mAVΩ port (LED doesn't light up) to replace the jumper wire. Did I burn out the fuse on the device?
Update: I checked the connections and settings on the multimeter and still 0,00.