1
$\begingroup$

I built a simple 4 channel 433MHz transmitter and receiver because I can't afford a remote controller. The range is limited to 3 feet and NFR24 transreceivers have a longer range, so my question is: can I replace the 433MHz modules with an NRF24 transreceiver and it'll work?

enter image description here

enter image description here

$\endgroup$
2
  • 1
    $\begingroup$ I wouldn't recommend creating your own wireless RC system. There is significant risk to causing damage to people/posessions if your improvised radio link cuts out while in the air. $\endgroup$
    – ifconfig
    Commented May 19, 2020 at 17:10
  • 3
    $\begingroup$ This post also might be better answered on Electronics.SE. (electronics.stackexchange.com) They have more experience with circuit design than many of us to here. $\endgroup$
    – ifconfig
    Commented May 19, 2020 at 17:11

1 Answer 1

2
$\begingroup$

Building your own radio system is a good exercise for understanding and appreciating the technology, but always remember to include a failsafe.

Regarding swapping modules, it looks like you are using the 432MHz modules which use On/Off Keying (OOK.) The work essentially by sending the state of a digital line, and support some serial formats like UART but also arbitrary pulses such as Pulse Width Modulation (PWM) and Pulse Position Modulation (PPM.)

However, the nRF boards communicate locally using SPI which is incompatible with the above. Without knowing more about your design it is difficult to say for sure how difficult this would be to integrate, but you will need a microcontroller at both ends. I can’t make out what the existing chips are – if you currently have a MCU you may just need to tweak a few lines of code but if you don’t, a more fundamental redesign may be needed.

$\endgroup$

Not the answer you're looking for? Browse other questions tagged or ask your own question.