Skip to main content

All Questions

Tagged with
5 votes
3 answers
919 views

Can I convert 50 amp electric oven circuit to subpanel, and power oven plus water heater, plus maybe a car charger?

My gas water heater is very old, and I'd like to replace it with a heat pump electric water heater. The one I'm looking at is 19 amps, 240 volts. My breaker box is in a finished part of my basement, ...
BaddDadd's user avatar
  • 337
1 vote
2 answers
101 views

Unsure if licensed electrician correctly wired old Zinsco 100-amp panel to new Siemens 200-amp subpanel

Our 1,572 sq. ft., 1972-built home in San Diego has a 100-amp Zinsco panel. We just learned that Zinsco busses and circuits are a known fire hazard. We talked to 4 licensed electrical companies, had ...
Kat's user avatar
  • 11
0 votes
1 answer
44 views

Can I temporarily power a 200A subpanel from a 100A feeder breaker? [duplicate]

Long story but I currently have a 200amp through-panel outside my temporary dwelling (lets call it the cabin) which feeds a 200amp panel inside the cabin (all of our circuits feed from the 200amp ...
Jason's user avatar
  • 1
0 votes
0 answers
32 views

Sub Panel location changed from side to the front side of the house access issue from the attic

Advice and idea's please The location of the subpanel has been moved from the side of the house to now the front. Coming out of the attic we would have to be in the Eave straight down. There is not ...
B Brown's user avatar
0 votes
1 answer
44 views

50 AMP sub panel in new shed

I have built a new shed and would like to install a 50 amp sub panel for power to the building. I did not install conduit into the slab. I will need to come up the side of the slab and then enter ...
Paul Grose's user avatar
0 votes
1 answer
53 views

PVC in wrong location need to transition from there to around the corner to subpanel [closed]

There was a 1" and 2 3/4 PVC ran to the wrong location they brought them up on the front corner of the house about a foot away from the edge . The subpanel is located a foot and a half from the ...
B Brown's user avatar
1 vote
2 answers
128 views

Why isn’t my service (Main) panel space being utilized and everything is being fed to a sub panel?

Edit: As requested please see the attached photos. @manassehkatz-Moving 2 Codidact Thank you for the reply. As you and a few repliers mentioned, I figured out how to upload some photos so hopefully ...
newhomeowner's user avatar
3 votes
0 answers
45 views

electrical conduit to panel connection question

I am in process of designing my solar system, but my questions are pure (IMO) electrical ones: My PV panels are connected to microinverters which are connected to J-box. I am planning to connect the ...
user166068's user avatar
1 vote
1 answer
89 views

Cost optimization for wiring electrical subpanel in my garage?

I will be installing a 100A subpanel in a detached garage. 100A for an EV charger and shop tools, and future proofing for a potential laneway house conversion. The garage is relatively close at just ...
Levi's user avatar
  • 494
4 votes
2 answers
780 views

200 A Main Panel pass thru lugs to 200 A Subpanel

I currently have a 200 A main panel outside my cabin. Inside is the main 200 A shutoff and on the bottom of the bar are 2- pass thru lugs. The panel is a Square D Model# hom816m200ftrb Panel has 8 ...
Matthew S's user avatar
1 vote
1 answer
46 views

Low voltage relay to control well pump -- would like run unswitched power to subpanel in shed by well

Well is about 130 feet down hill through woods from basement with 200A panel, pressure tank, and 120v pump switch. When they put in the well 17 years ago, I asked that they put in a cord so we could ...
Claude B's user avatar
1 vote
1 answer
93 views

Grounding a dryer to a subpanel

Related to Grounding a 3-prong dryer plug, but with a small twist. I have a NEMA 10-30 that runs back to my main panel. Since we had a leak in the laundry room, I'm having to open the wall. I'd like ...
Machavity's user avatar
  • 25.3k
4 votes
3 answers
2k views

Is a double 30 amp breaker powering three rooms bad?

I just a bought a house and discovered that a double 30 amp breaker is hooked up to three rooms with approximately 12-15 receptacles. Is this dangerous or am I good? Update: I have been informed that ...
Joel Pierce's user avatar
0 votes
1 answer
74 views

Can I add a 100 amp subpanel off my 200 amp service?

I am going to be installing a 100 amp breaker from 200 amp panel about 600 feet away. I have asked PUD to give me an average of power for the last year and the highest amount for summer and for winter ...
B Brown's user avatar
4 votes
3 answers
609 views

Proper way to extend circuits to subpanel

I would like to move 8 x 20A circuits (room lights, ceiling fans, outlets in the bedrooms, and living room), and 1 x 50A (AC) circuit from left main panel to the right sub-panel. The sub is a "...
utdrmac's user avatar
  • 141

15 30 50 per page
1
2 3 4 5
32