All Questions
Tagged with electrical subpanel
468
questions
0
votes
0
answers
32
views
Can I connect a 100 amp sub panel to a main that is 275 feet away? [duplicate]
Can I connect a 100 amp sub panel to a 100 amp main that is 275 feet away? I am wanting to run electricity to an outbuilding. What size wire should be used? I will be burying the cable in plastic ...
- 1
5
votes
3
answers
962
views
Can I convert 50 amp electric oven circuit to subpanel, and power oven plus water heater, plus maybe a car charger?
My gas water heater is very old, and I'd like to replace it with a heat pump electric water heater. The one I'm looking at is 19 amps, 240 volts. My breaker box is in a finished part of my basement, ...
- 347
1
vote
2
answers
106
views
Unsure if licensed electrician correctly wired old Zinsco 100-amp panel to new Siemens 200-amp subpanel
Our 1,572 sq. ft., 1972-built home in San Diego has a 100-amp Zinsco panel. We just learned that Zinsco busses and circuits are a known fire hazard. We talked to 4 licensed electrical companies, had ...
- 11
0
votes
1
answer
45
views
Can I temporarily power a 200A subpanel from a 100A feeder breaker? [duplicate]
Long story but I currently have a 200amp through-panel outside my temporary dwelling (lets call it the cabin) which feeds a 200amp panel inside the cabin (all of our circuits feed from the 200amp ...
- 1
0
votes
0
answers
34
views
Sub Panel location changed from side to the front side of the house access issue from the attic
Advice and idea's please
The location of the subpanel has been moved from the side of the house to now the front. Coming out of the attic we would have to be in the Eave straight down. There is not ...
- 1
0
votes
1
answer
44
views
50 AMP sub panel in new shed
I have built a new shed and would like to install a 50 amp sub panel for power to the building. I did not install conduit into the slab. I will need to come up the side of the slab and then enter ...
0
votes
1
answer
53
views
PVC in wrong location need to transition from there to around the corner to subpanel [closed]
There was a 1" and 2 3/4 PVC ran to the wrong location they brought them up on the front corner of the house about a foot away from the edge .
The subpanel is located a foot and a half from the ...
- 1
1
vote
2
answers
128
views
Why isn’t my service (Main) panel space being utilized and everything is being fed to a sub panel?
Edit: As requested please see the attached photos.
@manassehkatz-Moving 2 Codidact Thank you for the reply. As you and a few repliers mentioned, I figured out how to upload some photos so hopefully ...
- 11
3
votes
0
answers
45
views
electrical conduit to panel connection question
I am in process of designing my solar system, but my questions are pure (IMO) electrical ones:
My PV panels are connected to microinverters which are connected to J-box. I am planning to connect the ...
- 31
1
vote
1
answer
91
views
Cost optimization for wiring electrical subpanel in my garage?
I will be installing a 100A subpanel in a detached garage. 100A for an EV charger and shop tools, and future proofing for a potential laneway house conversion.
The garage is relatively close at just ...
- 494
4
votes
2
answers
785
views
200 A Main Panel pass thru lugs to 200 A Subpanel
I currently have a 200 A main panel outside my cabin. Inside is the main 200 A shutoff and on the bottom of the bar are 2- pass thru lugs. The panel is a Square D Model# hom816m200ftrb Panel has 8 ...
- 43
1
vote
1
answer
46
views
Low voltage relay to control well pump -- would like run unswitched power to subpanel in shed by well
Well is about 130 feet down hill through woods from basement with 200A panel, pressure tank, and 120v pump switch.
When they put in the well 17 years ago, I asked that they put in a cord so we could ...
- 11
1
vote
1
answer
93
views
Grounding a dryer to a subpanel
Related to Grounding a 3-prong dryer plug, but with a small twist.
I have a NEMA 10-30 that runs back to my main panel. Since we had a leak in the laundry room, I'm having to open the wall. I'd like ...
- 25.4k
4
votes
3
answers
2k
views
Is a double 30 amp breaker powering three rooms bad?
I just a bought a house and discovered that a double 30 amp breaker is hooked up to three rooms with approximately 12-15 receptacles. Is this dangerous or am I good?
Update:
I have been informed that ...
- 41
0
votes
1
answer
78
views
Can I add a 100 amp subpanel off my 200 amp service?
I am going to be installing a 100 amp breaker from 200 amp panel about 600 feet away. I have asked PUD to give me an average of power for the last year and the highest amount for summer and for winter ...
- 1
4
votes
3
answers
625
views
Proper way to extend circuits to subpanel
I would like to move 8 x 20A circuits (room lights, ceiling fans, outlets in the bedrooms, and living room), and 1 x 50A (AC) circuit from left main panel to the right sub-panel. The sub is a "...
- 141
2
votes
2
answers
108
views
"Main" panel wiring
At my property the power company installed the meter with a box below it with a 200 AMP breaker. There are lugs inside to attach wires directly to the bar so they feed directly from that breaker. So....
- 21
1
vote
0
answers
141
views
How are these old (1900s era) US screw-in fuse boxes internally connected?
(ignore the arrows)
The above pictures show the electrical panels in a house that was built in Illinois in 1909. I do not know for sure how original this wiring is, but I would guess that some ...
0
votes
2
answers
84
views
Running cable to sub panel 125amp
I am putting a 125amp sub panel beside my main breaker and am figuring out the correct wire sizes.
For the 2 hots to the sub-panel, I will use 1/0 gauge.
For the ground, I will use 4gauge aluminum.
...
- 101
1
vote
1
answer
53
views
Exterior 125A subpanel for pedestal selection
I am building an outdoors area in my backyard that will necessitate of its own subpanel. I have placed 2in PCV sch40 conduit in the ground and I plan to pull wires to power a 125A panel. I will mount ...
- 953
0
votes
1
answer
76
views
Want to feed a new subpanel from a grandfathered subpanel
I have a grandfathered subpanel that feeds my 5 ton package unit. 1988 install. Recently we added an AC system and they fed the condensing unit out of that sub panel and they tied the ground into the ...
0
votes
3
answers
82
views
How to make a 150a sub panel work with a 200a main panel when the max breaker size if 125a
Alright, folks.
I screwed up and overlooked part of this project before I started.
I have a 200a residential main panel. I installed a 150a subpanel 10 ft away to isolate service for a basement suite ...
3
votes
1
answer
256
views
Possible to convert disconnect to sub panel? [closed]
We've recently removed a hot tub that was originally installed in 1983. I'd like to know if it would be possible to convert the disconnect for the hot tub to a sub panel.
The breaker in the main panel ...
- 31
0
votes
1
answer
43
views
running new feeder from exposed-basement load center to basement wall-mounted subpanel, + adj. duplex receptacle, THEN outside for 2 deck circuits
Project Context: about to place deck boards on wholly redone, raised, attached, front of house/front door accessing, 6'x20' deck. We are in IL, just south of the WI state line.
Before laying these ...
1
vote
1
answer
105
views
Best way to power a nearby shed from house?
I have a seasonal vacation home on patio blocks (no foundation) and a 14 x 20 shed on the property - located about 8' from the house. The panel in the home was on an exterior wall, until an addition ...
- 11
0
votes
2
answers
103
views
Only 3 Wires going to a sub panel
I have an old Siemens sub panel (1990s) that I would like to replace soon. I took the panel cover off and and there is 3 wires (2 hots and a neutral). if I am correct, you need 4 wires (2 hots, a ...
- 21
2
votes
1
answer
60
views
How to bring 1/0 wire through foundation below grade?
I’m building an off-grid cabin in California. I have an array of solar panels that feed into an inverter and batteries in a small utility shed, connected to a 150A main panel. I want to run 125A into ...
- 21
0
votes
0
answers
52
views
Should I use cable or wires in conduit for my new panel?
I'm redoing basically all of my electric and upgrading to 200A. The plans are in another question (Is my new electric/subpanel plan correct?) but the relevant part for this question is:
Service ...
- 699
0
votes
1
answer
66
views
Cable sizing for subpanel
I’m in the process of finishing my basement. An existing 200amp Square D load center is in the basement. I want to add a subpanel in the basement about 75’ away. The subpanel will feed:
Dryer (50amp ...
- 41
0
votes
1
answer
45
views
Circuit Breaker Size For Main Panel
I'm planning on adding a sub panel to my basement. I purchased a Square D 100 amp panel. Is there any code requirement for the size of breaker I need in the Main? My neighbor used 50amp. I've seen ...
- 151