Skip to main content

Questions tagged [tubular]

The tag has no usage guidance.

6 votes
1 answer
432 views

Tubular tape width?

I want to equip my Koga Miyata Gents Racer with new (tubular) tyres. The rims are Mavic Monthlery Route Tubular Rims for which I have found the outer width to be 22mm (although I have found some sites ...
Julian's user avatar
  • 131
4 votes
2 answers
199 views

Older Zipp 303 tubular questions

I acquired old zipp 303 tubular wheelset. I am trying to figure out the following information. What is the year of manufacture. Specifically - if I had to replace one of the tires - what is the ...
curiousruby 's user avatar
4 votes
1 answer
165 views

How long can I leave tubular glue to dry on carbon rims?

I have some Continental Sprinter tubular tyres to glue onto some carbon rims. I have bought Continental carbon rim cement and the tyres have been stretching at 140 psi on the rims for a few days (>...
Swifty's user avatar
  • 12.9k
4 votes
1 answer
120 views

Tubular glue remover for CARBON

Trying to find a tubular glue remover that won't eat carbon. Acetone is a no (unless very dilute??) and apparently so is the top brand that claims to be carbon safe (see picture). Any ideas?
JenkemSuperfan's user avatar
3 votes
2 answers
269 views

I need 27 x 1 1/4" sew up tires

What is the new teminology for 27" x 1 1/4" sew ups? There are so many new sizes. It seem like 32-630 would be right, but I can't find any that arn't clinchers. I need new sew ups for my ...
Warren's user avatar
  • 31
10 votes
2 answers
1k views

How do tubular sizing standards actually work?

Clincher sizing standards use the diameter of the bead and bead seat along with rules for where to measure and the dimensional profile of the bead and bead seat. Tubulars don't have beads or bead ...
Nathan Knutson's user avatar
6 votes
2 answers
1k views

How can I clean these wheels?

These are my old vintage bike rims. How can I clean them?
Liedekerke's user avatar
0 votes
1 answer
384 views

How do I get/check if carbon wheels are tubeless compatible

I have fake Zipp 404 and Continental GP4000 SII tubular on it. It is time to change it. The question is how do I know if this wheels a) without removing b) with removing tubeless compatible or not?
Emin Hasanov's user avatar
6 votes
1 answer
379 views

Does my rear tubular tire need to be replaced?

Does my rear tubular tire need to be replaced? It still holds air but I am concerned about my ride safety
Drewskiii's user avatar
5 votes
3 answers
2k views

tubular tire replacement

So two days ago I bought this Peugeot vintage bike (from the '80s) and it has tubular tires on it that aren't usable anymore. Is it possible to install a normal tire on the same rim instead? I'm a ...
enniius's user avatar
  • 61
0 votes
3 answers
4k views

Can I use a Tubular tyre in a Clincher rim?

Just tried it - my trekking clincher rim was too deep, so have to use 4 layers of tape to keep side out of rim, but then tubular started to travel forward even during slow acceleration. Would you try ...
Jan's user avatar
  • 344