0

Recently I've upgraded to windows 10 and facing a problem with connecting to my workplace cisco vpn. Cisco vpn client refused to work. So I opted to install shrew soft vpn client. It says tunnel enabled but then no traffic seems to pass. I can't ping or do RDP or ssh to the necessary servers. Can anyone be of any assistance? Thanks in advance.

Some logs:
config loaded for site 'IP'
attached to key daemon ...
peer configured
iskamp proposal configured
esp proposal configured
ipcomp proposal configured
client configured
local id configured
remote id configured
pre-shared key configured
bringing up tunnel ...
network device configured
tunnel enabled
Improve this question
4
  • Which version of shrew are you using?
    – algiogia
    Commented Sep 8, 2015 at 8:47
  • Standard edition of 2.2.2-release.
    – chilli10
    Commented Sep 10, 2015 at 1:40
  • I managed reinstalling Shrew and restarting Windows. It actually took a few attempts as I tried with older versions. I finally reinstalled 2.2.2 then had to reboot 2 times and it worked.
    – algiogia
    Commented Sep 10, 2015 at 9:51
  • I had already reinstalled several times and rebooted system. But still the same problem.
    – chilli10
    Commented Sep 11, 2015 at 17:12

1 Answer 1

Reset to default
-1

I had the same problem more often now. In my case reboot solves the issue.

When I go to Network tab and find the counter "Established - 0" I know I need to reboot :(

note I'm using v2.1.7

Improve this answer

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .