2

I have a debian 3.0 woody installation. I have eth1 and eth0 being randomly switched at reboot. I cannot figure out how to set a manual way to make this always associate to that network card. It is essentially switching network cards at boot which causes a lot of problems.

Any help would be appreciated.

Improve this question

1 Answer 1

Reset to default
2

Try one of the methods suggested here: http://www.science.uva.nl/research/air/wiki/LogicalInterfaceNames

The most natural one (using udev) is probably not available on a woody system.

Improve this answer

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .