3

I have a home wifi network that I want to access remotely via VPN.

I want to access files/folder that I have shared and the internet access through my home wifi (not from my local wifi) - That is I want the default bhaviour of VPN

My router (speedtouch 780WL) at home gets assigned a dynamic ip address from my ISP. In my router I have a feature to assign public IP to a computer. Which I have done so. Hence when my home computer is turned on it is assigned the public ip address of my router.

As a result of the above change in my router configuration the ip that gets assigned to my person computer is like 117.7.3.30 other computers on the same network are assigned ip addresses like 192.168.1.65 , 192.168.1.66 and so on.

The gateway/router ip address within my home netwrok is 192.168.1.254

Now from outside the network I can access 117.7.3.30 ip which accesses my home computer which is perfectly fine.

The problem

In my home computer (windows 7 pro) In the network connection I have created a new incoming network connection using default settings. which has 'Allow other to access my local network' and 'assign ip address automatcally using dhcp' enabled

When I remotely connect to my home network thourgh vpn I can access my files/folders on the network but there is no Internet access.

The VPN connection status says 

IPV4 Connectivity no Internet access.  
IPV6 Connectivity no Network access.

The description says

 DHCP enabled no
 IPv4 address 192.168.1.66
 IPv4 subnet mask 255.255.255.255
 IPv4 default gateway   Empty
 IPv4 DNS server  192.168.1.254
 IPv4 WINS server  Empty
 Netbios over tcpip enabled Yes

Any ideas why internet is not accessible ? My suspicion is the default gateway which is empty in the details of VPN connection should have been 192.168.1.254 which address of the router. Even though in the VPN client connection properties -> Networking IPV4 -> properties -> Advanced -> use default gateway on remote network is checked.

Improve this question
1
  • 2
    Additionally, by giving your computer the public IP of your connection I hope this also doesn't put that device in your modem/router DMZ and, essentially, open all ports to that device... that's just looking for trouble with a Windows box (if you haven't taken due care to manage the firewall rules)...
    – Kinnectus
    Commented Jun 29, 2018 at 11:35

2 Answers 2

Reset to default
0

Listed a few things that I needed to so to overcome the same situation on Windows Vista and Windows 7:

  1. Ensure the 'IP Helper' service is running. On my machine having it set to manual wasn't enough for it to start when needed. Definitely needed on the client machine not sure if needed for the server also.

  2. The network setting on the VPN server needed to be static IP addresses not DHCP. As per information posted elsewhere the IP address needs to be on the same network.

I suppose the only new information I posted which I couldn't find else where was the IP helper service. Hence the reason posting this message; for the next unlucky person tearing there hair out.

Improve this answer
0

Turn off DHCP on the server (being that you want the router handing it out, not your PC since you're bridging VPN clients onto the local network) and turn on DHCP on the client, which should let it grab an IP dynamically (unless you need it static?). Either way, your router and server both answering DHCP broadcasts for the same subnet is going to cause trouble.

P.S. That subnet mask is crazy wrong too, because it creates an empty set. It probably needs to be 255.255.255.0 for a home network. So you likely couldn't even ping the router as-is, because as far as the VPN client is concerned it's on a one (or no?) machine network.

Improve this answer

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .