All Questions
14
questions
7
votes
2
answers
1k
views
Is it possible to interchange these two sockets since the cables in the wall look the same?
My Ethernet socket isn't working and I'm convinced it has to do with either the socket itself or the cable behind the wall. This picture of my wall sockets (the left the Ethernet socket, the right a ...
0
votes
0
answers
157
views
Issue with network cable
We recently had a garden studio installed in our back garden and I asked them to lay a network cable (steel armoured) from the front of the house, where the main router is located, to the garden ...
0
votes
0
answers
96
views
Powering USB Cable From Different Head
I Have a Mikrotik RB951UI-2HND router, and a Huawei E5577 Modem Wi-Fi with modded firmware so it can run without battery (directly from power source). So I want to connect the two together with USB ...
1
vote
0
answers
245
views
Cat 5 Terminal Wiring
I bought a house where most of the rooms (including my office) have been wired in with cat5 cable and they all run to the terminal block seen in the attached pics which is in the basement. Yesterday I ...
1
vote
0
answers
801
views
What are the effects of different wire lengths on a single Ethernet cable?
Typically the wire lengths inside an Ethernet cable are all relatively equal. I know there must be some slight variance between the length of the individual wires inside cable due to some twisting ...
3
votes
1
answer
364
views
Terminating solid Ethernet in a pull out rack
How should I terminate solid Ethernet cable in a shallow rack?
Information
I've wired my house with solid CAT7.
It terminates in a double gang.
The wiring cabinet can fit a 300mm equipment rack
The ...
0
votes
1
answer
1k
views
Cat5E UTP transmission speed
As I have understood Cat5E FTP (STP) cables support up to 1000mbps transmission rate. But I have seen them in stores that describe them of being capable of only 155mbps trx. Do both kinds exist? Or ...
2
votes
4
answers
1k
views
How could I identify the usable Cat-5 pairs in this mess of torn-out wiring?
When the previous occupants vacated my new lab space they did a number on the Cat-5 wiring that had previously been installed.
The baseboard jacks at the other end of this mess appear to be okay, ...
0
votes
2
answers
10k
views
How can I wire my case fans to be powered by my PSU and not motherboard?
My case fans are plugged into my motherboard and I have no more slots for fans. I read from a source on yahoo answers I should wire all my case fans to a molex 4 pin adapter--and plug that directly ...
0
votes
4
answers
1k
views
Ethernet run tests green but won't connect
I have a single ethernet run at home that I just added. I have a cable tester that tests for pin/pair crossover or miswired pins. The entire line tests green (all 4 LEDs light up green on the tester) ...
2
votes
4
answers
5k
views
Network cable third pair not firing - can I switch pairs?
Is it true that computers only need three of the four pairs to transmit data? I have the third pair on a very long wire, goes through conduit, etc. Can I switch one of the pairs and make it work?
...
3
votes
9
answers
23k
views
Is there an easy way to straighten network cable individual wire pairs?
Is there any easy way to straigten the pairs in a cat 6 cable? I've been making network cables lately, and I was wondering if there was a trick other than just a lot of practice for straigtening out ...
2
votes
3
answers
5k
views
What is the best way to go about running Cat6 over 100 meters?
I have two building about 300 meters apart that I would like to network together using Cat6. I would prefer to wire them together instead of using wireless if possible. Please let me know of any ...
23
votes
14
answers
20k
views
Running CAT 5 cable outdoors
I'm trying to extend my network to an unconnected garage that's about 20 yards away from my house. What's the best way to do this?
Is there special outdoor-rated CAT5e/CAT6 I should use?
If put it ...