Skip to main content

All Questions

Tagged with
0 votes
1 answer
54 views

Host getting multiple IP addresses

I have 2 raspberry pi's running in my house with intermittent connectivity and both get dhcp addresses from my DHCP server. eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 10....
Nathan's user avatar
  • 101
0 votes
0 answers
907 views

Cant connect via SSH or XRDP over wireguard

I have a wireguard server and 2 wireguard peers connected to the server. All 3 can ping each other on the wg0 interface, but the 2 peers cannot connect to each other. I have found where people had ...
thespartin's user avatar
0 votes
0 answers
669 views

How to setup a access point on my raspberry pi zero w? (Re-Ask)

this is a duplicate of my first question. Since I found out more info about the topic, but not the answer yet, I will update the question. Here is the new info I found out: My TP-Link WN722N eu is ...
CacheZero1's user avatar
0 votes
1 answer
757 views

Connecting to a home server on a cellular hotspot

I am seeking advice on a networking issue I have run into recently. I suspect that I a making an obvious mistake in my assumptions about connections between machines on separate networks. My goal is ...
ivanovich's user avatar
4 votes
1 answer
701 views

Why can’t I access a device with 4G modem connection over the internet when I can connect to another device with a 4G connection without issue?

I have a Raspberry Pi device where I use a 4G modem (D-Link DWM-222) to connect it to the internet. The interface PPP0 gets an IP and everything works great. I was thinking that I would get a public ...
Andreas Larsson's user avatar
0 votes
1 answer
952 views

Correct flag to use instead of --icmp-type?

I am trying to set up iptables v1.8.7 on a Debian 11 Raspberry Pi to block ICMP timestamp requests and replies. The tutorial I am following and all the other forums I have looked at say to use the ...
SuperDialga's user avatar
0 votes
1 answer
5k views

dhcpcd.conf for both static and dynamic ip address

Long story short: I need to configure two interfaces for one physical interface, one with a static and one with a dynamic ip address. I know how to do it in /etc/network/interfaces but my box uses ...
Michal Oprendek's user avatar
1 vote
1 answer
624 views

Iptables-restore does not work with SNAT

I am using Raspbian on a Raspbery Pi (based on Debian 10) and I'm trying to use the following line in my iptables rule set: -A POSTROUTING -s 2.3.4.5/26 -o eth0 -j SNAT --to-source 1.2.3.4 However ...
paymegood's user avatar
0 votes
0 answers
419 views

After removing pi-hole my eth0 does not working at all

I uninstalled pi-hole from my raspberry pi 4 and got lost ethernet connection. Only orange led is working. Ifconfig shows only lo, but with flag -a it does show eth0. I can run ifconfig eth0 up and ...
Meliborn's user avatar
  • 111
1 vote
1 answer
224 views

Raspberry - APT : host not found - Can not update - DNS resolution issue

Since a few weeks, I have some troubles to update apt repositories on many Raspberry / Raspbian devices. I got DNS resolution issues, on any mirror I've tried in /etc/apt/sources.list when I use apt-...
Damien C's user avatar
  • 111
1 vote
1 answer
1k views

Unable to start dnscrypt-proxy on raspbian

I am using a Raspberry Pi Zero W. The OS is Raspbian Buster. I installed DNSCrypt-Proxy but was unable to start it. Checked it with sudo systemctl status dnscrypt-proxy. Got [FATAL] listen udp 127.0.0....
Gaurav Joseph's user avatar
1 vote
0 answers
122 views

Server connections refused when hostname used, works fine with IP

Hope someone can help. I've run a local server for a while on a Rapberry Pi 3b (Raspbian Buster) that includes a PBX server, DNSmasq and local webserver. I recently upgraded to a Pi4 and performed a ...
Ian Bishop's user avatar
0 votes
0 answers
338 views

Wireguard VPN for home network with raspbery pi4 8Gb (64bit)

I've been trying to set up a wirguard VPN on my home network and been having a frustrating time I think I have solved all the ususal issues but I'm still not able to access the internet or things on ...
Richard J. Acton's user avatar
1 vote
0 answers
179 views

How do I join my Raspbian server to a VLAN?

Just so I don't waste anyone's time, I am not looking to join two networks on one network adapter or route between Wi-Fi and Ethernet. I have a Netgear managed switch. My Raspberry Pi is attached to a ...
PrestonDocks's user avatar
0 votes
1 answer
204 views

Raspbian Buster won't connect to network unless the console is displayed

We get to the point where I really don't know what to fix now. Basically, I have a Raspberry Pi running Raspbian Buster, and I don't know why but connecting to the network, make it wifi or wired, ...
MaxouMask's user avatar
  • 101

15 30 50 per page