Skip to main content

All Questions

Tagged with
7 votes
3 answers
2k views

What is this no-harness rappel called?

I found an old police service magazine from 1969 and it has an article named "a day out with the police mountaineering section" In there I saw the picture below of a guy rappelling with ...
Henry F's user avatar
  • 73
13 votes
2 answers
2k views

Is this harness defective for having the belay loop around the belt webbing instead of the tie-in loop?

I am a beginner to climbing and bought this ClimbX harness from Go Outdoors in the UK. Someone at the gym today told me it is defective because the belay loop passes through the thin piece of webbing ...
egg's user avatar
  • 233
6 votes
1 answer
289 views

Can a full body harness help reduce the chances of suspension trauma?

Those who are well-versed with rock-climbing (and other variants of climbing) are aware of the dangers posed by Suspension Trauma. Here at The Great Outdoors there had been a healthy discussion on ...
WedaPashi's user avatar
  • 31.7k
5 votes
1 answer
634 views

Why are full body harnesses uncommon in mountaineering?

In principle, it is known that full body harnesses are useful for situations where the center of gravity is higher - e.g. for children, or for Alpine situations involving carrying heavy loads. A full ...
ahron's user avatar
  • 1,841
16 votes
5 answers
5k views

How to instruct someone how to take off a climbing harness?

After rappelling near waterfalls, or during the rain, the harness often becomes wet and hard to remove -- particularly for inexperienced people. How can I instruct someone in how to remove the ...
WedaPashi's user avatar
  • 31.7k
8 votes
4 answers
1k views

Is there any evidence that attaching a biner to both seat and leg loops results in a 3-way load?

It is commonly known that loading your carabiner in three directions is bad, as it reduces it's strength. This is apparent when talking about belay stations, as e.g. described in this blog post by the ...
imsodin's user avatar
  • 21.7k
11 votes
3 answers
2k views

Climbing harness: clip two carabiners to avoid cross-loading

For reasons of time-saving and avoiding retie figure 8 knots all the time, can I clip the figure 8 knot via two carabiners each clipped to either loop of the harness? This way there will be no cross ...
Gregory Stein's user avatar
5 votes
1 answer
438 views

Can I use a rescue harness for recreational climbing? [closed]

I bought a sport harness and a rescue harness. I'm just wondering if i can use them interchangeably.
John nguyen's user avatar
3 votes
1 answer
358 views

How fast does suspension trauma happen?

In this question I asked about suspension trauma and why it's effects come to be. Apparently the main reason is reduced blood flow/ circulation. This is due to blood vessels being constrained/pressed ...
fgysin's user avatar
  • 13k
8 votes
2 answers
3k views

Can I fall out of my sit harness?

In sport and trad climbing, a sit harness is widely used (except for children). However, I wondered if there is the possibility to fall out of it? One situation where I could see this happen is in ...
Paul Paulsen's user avatar
  • 4,329
20 votes
2 answers
4k views

Why does suspension trauma happen?

This question once more brought up the topic of suspension trauma. I tried to read up on the topic, but found that the Wikipedia page was not as informative as I would have liked. Especially I'm ...
fgysin's user avatar
  • 13k
7 votes
3 answers
701 views

When climbing, how far should the tie-in knot be from the harness?

Recently I heard as a general rule of thumb that one should leave at most the width of your hand as space between the knot (a figure eight for instance) and the harness. Its quite obvious that one ...
ftiaronsem's user avatar