All Questions
6
questions
0
votes
1
answer
65
views
Understanding L2 Switch (Network Noob)
I currently have the setup on the left and it works just fine...
I use it to transfer data between laptop and embedded systems hardware device. (Data...Not internet)
Question:
What would the set up on ...
1
vote
1
answer
755
views
Full Duplex and Half Duplex Channel Capacity
As far as I know about full and half duplex, if we have a channel with bandwidth 10Mbps then in full duplex both sender and receiver can transfer 10Mb in both directions at the same time and in half ...
2
votes
1
answer
227
views
How can I figure to connect my NVR in this topology? [closed]
I´m trying to configure a NVR to my company´s network.
There is a router from which I will assign a fixed public IP to the NVR.
I could connect the NVR directly to the Router which has 5 different ...
10
votes
1
answer
8k
views
If two NICs are bonded and connected to different switches how does a router decide which switch to forward the packets to?
I am trying to understand how the architecture works in case of NIC Bonding. The scenario is: There are 2 NICs on the same system. Both are bonded to support failover and load balancing. Hence the IP ...
4
votes
4
answers
2k
views
CPU Impact of "debug ip packet" on Cisco Switches
in terms of CPU consumption and possible traffic disruption, what should I generally expect when I run the command:
Switch#debug ip packet
on a Cisco device in a large ISP network?
Cisco devices in ...
5
votes
1
answer
1k
views
IGMP snooping in iptv
Host1 wants to join Multicast group as IGMPv3 include (G,S). The same group and source Host2 send as Exclude(G,S) report. what process done in switch?