All Questions
6
questions
0
votes
1
answer
18
views
Calulating the compression deformation using strain data measured by strain gauge _ material engineering
I'm studying material engineering and conducting some experiment.
The experiment was measuring the strain of long steel bar.
The bar is compressed from left side and deformed shortened.
Using strain ...
- 1
0
votes
1
answer
176
views
What would happen if we applied a stress greater than the yield stress to a rigid-perfectly plastic material?
Say we had a material that was rigid perfectly plastic, with a stress-strain characteristic as shown:
Say that we are drawing this material through two dies, something like this:
What would happen ...
- 117
6
votes
2
answers
169
views
Yield properties of plastic material
What is meant by yield of isotropic plastic material?
How is yield of Isotropic plastic material different from the term normal yield which is referred as transition from elastic behaviour to plastic....
- 87
2
votes
1
answer
53
views
Behavior of materials on application of tension
Does a test body subjected to a strain that causes plastic deformation still have elastic recovery?
- 121
0
votes
1
answer
95
views
Is there an standard description for deformation at each point on a body?
I'm trying to come up with a way to describe deformation on a body at each point on that body. My problem can be expressed and solved in two dimensions. Given two triangles, one being the initial ...
- 101
2
votes
1
answer
214
views
Finding initial length of a bended plastic sheet (Bend Allowance)
I have a 1.5 mm thick plastic sheet part which hast to be bent at a joint 0.3 mm thick by ~ 10 Deg. I know (found from design drawing) compressed and stretched lengths of the joint. How can I find the ...
- 23