All Questions
Tagged with transceiver ethernet
9
questions
0
votes
0
answers
67
views
How do transceivers interact with the Ether bus in classic Ethernet?
I am reading Computer Networks 5th Edition [Tanenbaum/Wetherall] and there is the following diagram section 3.1 about classic Ethernet.
I am a bit confused on how to interpret the physical connection ...
0
votes
0
answers
116
views
Ethernet 100 BASE-TX Question
I'm using this Ethernet transceiver PHY to study the working of the RGMII interface.
I just want to understand 2 things.
1. What would be the output and input differential voltage levels on the pins 2,...
1
vote
1
answer
42
views
Ethernet Transceiver Modem block scheme: 50:50 device in block scheme
This is a system architecture of the Optical Ethernet Transceiver Modem (OETM)
which allows a bidirectional transmission of optical signals and electrical signals (Ethernet). Given an optical input ...
2
votes
2
answers
1k
views
SFP+ 10GbE Module Interface
I'm in the process of learning about how SFP+ modules work under the hood. I chose a 10GBASE-T transceiver module as my case study. The module I chose is said to be complaint with SFF-8431 spec, so ...
1
vote
1
answer
855
views
10GBASE-R 64B/66B Encoding/Decoding Unusual Control Block Formats
I need to design a 64B/66B decoder on receiver side of the GTY transceiver. Currently, I get 2 bit header and corresponding 64 bit descrambled payload at positive edge of every other clock cycle. So ...
1
vote
2
answers
661
views
Gearbox in 10GBASE-R Ethernet protocol
In 10GBASE-R specification, Gearbox is defined to take care the data width adaptation between PCS & PMA. For example, after the 64b66b encoding, the PCS data width will become 66bits.
The gearbox ...
1
vote
2
answers
202
views
What technology to use to send data/Ethernet (about 128 kbps) over copper cable (4km)?
What thechnologies can i use to send data/ethernet (w/ a symmetrical traffic throuput of about 128kbps) over copper cable (4km)?
1)SHDSL would be an option !!(but I couldn't find any chip with ...
4
votes
2
answers
2k
views
On-Board connection of ethernet transceivers
Is it possible to connect two 1000-BaseT transceivers with each other? I have two transceivers, each of them has 4 twisted pairs that actually are meant to be connected to an RJ45 connector including ...
2
votes
2
answers
4k
views
Vitesse VSC8221 Ethernet PHY for Media Converter Application
I'm currently designing a media converter board using Vitesse VSC8221. Just as an FYI, the documents for this product are all available at the product page. No NDA is required.
When I say media ...