All Questions
Tagged with stepper-driver cnc
5
questions
0
votes
0
answers
103
views
Why extending the wire of stepper motor leads to vibration?
I'm almost newbie in hobby electronics and I'm trying to extend the wires of my Nema17 stepper motor. (Model: Stepperonline 17HS13-0404S1, 12V, 0.4A) But somehow extension leads to vibration.
It's ...
- 113
0
votes
1
answer
1k
views
Stepper motor skipping steps until I lower voltage
I have four of KL23H2100-35-4B stepper motors on my 3-axis CNC (doubled up on the y-axis); these are 3.5A 4-wire bipolar stepper motors with a rated 2.8mH inductance.
I am driving them with the ...
- 3
1
vote
0
answers
509
views
Why stepper motor is slow with A4988 driver?
I'm using NEMA17 17HS13-0404S1 stepper motors with Arduino CNC Shield & A4988 drivers but I think they're much slower than they should be. Hard to explain how slow they are but compared to Ender 3 ...
- 113
0
votes
1
answer
456
views
Building a water jet cutter using Arduino, CNC shield and GRBL firmware
I am building a water jet cutter using Arduino Uno and CNC shield for control.
The CNC shield uses A4988 drivers to control the stepper motors. I uploaded the GRBL (for this shield) firmware to ...
- 15
0
votes
1
answer
4k
views
Power Supply for Nema 17 motors [closed]
I'm using below things to make cnc plotter and cnc lathe :
3x Nema 17 Motor, CNC shield v3, 4x DRV8825 driver, 3x Endstop, Arduino UNO
Some where in the post I read that if there is a CNC with 3 ...
- 103