All Questions
7
questions
1
vote
1
answer
300
views
Soldermask bridge gap too small - PCBWAY
I've got a PCB design which contains a chip that uses the QFN (7x7) package.
Because of the package size the pins are very close together and the pads are 0.2mm apart, which is smaller than the ...
- 131
4
votes
2
answers
1k
views
Placing through hole and SMT on the same side
I have a design with huge push buttons (with 6 TH holes.)
There's a few of them so they do take up quite a bit of space mechanically from the top.
I was thinking of placing the majority of the SMT ...
- 757
1
vote
4
answers
378
views
Choosing a PCB Manufacturer/Assembler for the first time [closed]
I've just finished designing my first PCB, and I'm about to send out a batch of emails for quotes from manufacturing/assembly shops. My design is super simple: the only components are 7 identical SMD ...
- 303
0
votes
1
answer
2k
views
Half-etched fiducials Vs through-cut fiducials
While making PCB, I added 8 fiducials (fids) marks so that pick and place machines use these marks as referent points on the PCB to position the surface mount components (Packages) during assembly.
...
5
votes
3
answers
1k
views
Good way to affordably manufacture low-quantity PCB?
I am thinking about making an open-source development board for a specific field in power conversion.
If there is interest from local universities, I will manufacture a few hundreds of these boards. ...
- 1,656
4
votes
1
answer
1k
views
From what pitch should I consider ENIG finish
My design (4-layer, FR4, 1.6mm) has a couple of ICs with 0.5mm pitch pads and some LEDs with 0.4mm pitch pads, very small LEDs.
Should I consider ENIG (more expensive) or will HASL do the job?
I read ...
- 2,127
6
votes
1
answer
848
views
How do PCB fabrication houses make PCBs?
I know the different ways of making PCBs at home, but I can't seem to find a lot of information on how board houses professionally make their PCBs. Is this how they do it?: http://www.youtube.com/...
- 4,546