Timeline for What is the best solution for wire to board then board to board connection?
Current License: CC BY-SA 4.0
11 events
| when toggle format | what | by | license | comment | |
|---|---|---|---|---|---|
| Apr 18 at 11:41 | answer | added | DerStrom8 | timeline score: 0 | |
| Apr 17 at 20:59 | comment | added | Voltage Spike♦ | @Visioncoop How is this different from your question yesterday? What research have you done? Have you looked at all the connectors in the digikey catalog? | |
| Apr 17 at 20:55 | comment | added | InBedded16 | @Visioncoop btw I would recommend going with the idea on the left side of your drawing. They dont have to "share the same pads", you can route the signals from the top layer of your PCB to the bottom layer using vias. Then you would have: one right-angle (from the side) wire-to-board connector on the top. One vertical (from the top/bottom) board-to-board connector on the bottom. The vertical mating connector to that one on the top of the bottom PCB. | |
| Apr 17 at 20:50 | comment | added | InBedded16 | @Visioncoop new information like this should be edited into your question rather than clarified in the comments - just makes it easier for readability :) | |
| Apr 17 at 20:16 | comment | added | Visioncoop | I am locking in, These are the new clarifications, the wire to board connector has to come in from the side. then the top board to board connection has to then somehow connect to the bottom board to board connection. IF i can find these impossible parts I will be able to speedrun through the rest. the wire to board and board to board connection do not need to latch on to eachother anymore | |
| Apr 17 at 20:06 | comment | added | vir | The good news is if you pull this off you'll probably have a good shot at a position since "the person who knows all the connectors" is a pretty important niche spot. The bad news is that's because no one wants to do it! | |
| Apr 17 at 19:41 | answer | added | InBedded16 | timeline score: 0 | |
| Apr 17 at 19:37 | comment | added | jsotola | duckduckgo.com/?q=arduino+shield&iax=images&ia=images | |
| Apr 17 at 19:33 | comment | added | Visioncoop | I have a 24 volt power supply that is coming in and going to be powering a camera and encoder signals are also coming in. The current requirements I have no real clue about. I gotta figure that out as well. | |
| Apr 17 at 19:31 | comment | added | vir | Some combination of 0.1" headers with sockets and/or long tails maybe? What voltages, currents, signals, etc are you working with here? | |
| Apr 17 at 19:21 | history | asked | Visioncoop | CC BY-SA 4.0 |