Unanswered Questions
54 questions with no upvoted or accepted answers
7
votes
1
answer
1k
views
Alternative to 5-speed twist shifter for Shimano Nexus 5-speed IGH?
I'm going to buy a SG-C7000-5D / SG-C7050-5D and don't want to use the twist shifter. Unfortunately there aren't many 5-speed flat bar shifters around theses days. I've searched for alfine shifters, ...
- 5,202
4
votes
0
answers
279
views
Sram AXS derailleur does not shift
Have you encountered a problem where a rear AXS derailleur stops shifting? Any suggestions?
I bought a mint 2023 GX AXS derailleur on Marketplace, it worked for the first short test ride on a road but ...
- 141
3
votes
0
answers
70
views
How to properly adjust front derailleur height when it can sway significantly once the clamp bolt is loosened up?
I'm trying to adjust derailleurs myself, for the first time .)
the model is DEORE XT
following the how-to
https://www.wikihow.com/Adjust-a-Shimano-Front-Derailleur
the very first step - adjusting its ...
2
votes
0
answers
33
views
How can I make my vintage sturmey Archer AW hub take a 3 speed cassette? (Minimal metal work, none if possible)
So to make answering my question easier, I'll start with the goals, I wish to be able to attach a 3 speed cassette and tensioner (relatively low cost) to my vintage Sturmey Archer AW hub so i can have ...
2
votes
0
answers
26
views
7 speed hub whistles
My 7 speed Nexus internal axle begins to whistle as speed increases, but noise stops when I slow down. Has nothing to do with the pedal crank.
- 5,202
2
votes
0
answers
50
views
Something like chainsuck on RD lower pulley after new crankset install?
I just switched out a Shimano M5100 crankset for a SRAM GX Eagle crankset. I am using a KMC X11-EL chain. I cleaned the chain before installing it with the new crankset. My RD is a Shimano SLX 11-...
- 2,090
2
votes
1
answer
243
views
Upgrading Shimano Acera 8 speed Rear Derailleur to 8 speed Shimano XTR derailleur
Looking for some help here. I am upgrading Shimano Acera 8 speed rear derailleur to 8 speed Shimano XTR rear derailleur and it appears that because the old 8 speed XTR derailleur has a clip for the ...
CommunityBot
- 1
2
votes
0
answers
60
views
clicking chain on 3rd gear only
Shimano DI2 11 speed XTR on my gravel bike. The 3rd from smallest gear on the cassette makes a clicking sound. Any other gear its fine. Cassette and chain are fairly new. Have reindexed, checked ...
- 21
2
votes
0
answers
133
views
U.S. source for Alfine 11 oil for oil changes?
Yesterday I changed the oil in my Alfine 11-speed hub. I bought the 50ml bottle of SG-S700 from an eBay seller in Florida, the last one in the site's search results originating from the United States. ...
- 639
2
votes
0
answers
232
views
Does (or has in the past) an adaptor existed to mount a disc rotor to a Shimano Rollerbrake type hub?
I have acquired a Nexus 8speed rear hub. It’s a good one and I’d love to use it. However, it has been set up to use rim brakes and under the plastic cover is the interface to mount a rollerbrake. Does ...
- 14.6k
2
votes
0
answers
156
views
Why is my Sturmey-Archer 5-speed hub sticking between 1st and 2nd gear?
I've been trying to set up a Sturmey-Archer X-RD5 (W) hub to no avail. I can get it moving between 2nd and 5th gears just fine, but as soon as I pull it into 1st the indicator rod (and I assume ...
- 173
2
votes
0
answers
141
views
Rear wheel not centred
I've been trying to fit a second rear wheel to a fracing frame rebuild and I've noticed it is very off-centre. You can see from the pictures that it is much closer to the non-drive side than drive ...
- 591
2
votes
0
answers
416
views
Using 11-36t 9 speed derailleur with 11-40t 9 speed cassette
So I've got the shimano altus rd-m2000 and it says that it only supports 11-36t. However, I've seen people on forums say that it's possible with this derailleur. Even it I was wondering if with a ...
- 21
2
votes
0
answers
835
views
Why do SRAM rear derailleur not have a parallel movement
My SRAM rear derailleur (Rival 22 circa 2016) has a non parallel movement. When it is in the lowest gear, the cage and pulley sprockets align with the cassette sprockets, but when it's in the highest ...
2
votes
0
answers
3k
views
Shimano Nexus 3 coaster brake screeching sound
When I brake hard/er with my Shimano Nexus 3 coaster brake it makes a loud screeching sound. Like really loud, everybody on the street would hear it and turn around. Since I know it's all internal all ...
- 352