Unanswered Questions
64 questions with no upvoted or accepted answers
6
votes
0
answers
109
views
What is forward drag on a coaster brake
I have a single-gear coaster brake bicycle that needed fixing. I would have to pedal real hard to get it to go and backpedal a block in advance for bike to stop. Very spongy brakes. Well I took brake ...
- 13.9k
5
votes
0
answers
3k
views
SRAM XD cassette will not fit on the splines of an XDR driver
I have an 11 speed 10-42 XD cassette that I am trying to fit on an XDR driver (this one - https://www.alltricks.com/F-41493-pieces-roues/P-676097-fulcrum_body_sram_xdr). No matter how I turn the ...
4
votes
0
answers
297
views
Sram AXS derailleur does not shift
Have you encountered a problem where a rear AXS derailleur stops shifting? Any suggestions?
I bought a mint 2023 GX AXS derailleur on Marketplace, it worked for the first short test ride on a road but ...
- 141
3
votes
0
answers
599
views
Help identifying a Bianchi track frame
I've been trying to identify this Bianchi track frame - any help would be appreciated! Closest I've come is Eco Pista from early 80s, but I'm absolutely no expert on the matter.
The numbers on the BB ...
- 31
2
votes
0
answers
46
views
Why have my rim brakes started making a scraping noise?
I bought a bike about 7 months ago, and I've noticed over the last few weeks that it's started making an unpleasant scraping noise when I brake. Does anyone know what might be causing this and how to ...
- 121
2
votes
1
answer
74
views
Sram/Avid brake hose compatiblity
I have Sram Rival AXS which I want to transfer from one bike to another. Unfortunately the new bike is bigger (M -> XL) so new brake hose is required. SRAM recommends SRAM Brake Hose Kit - Double ...
CommunityBot
- 1
2
votes
0
answers
50
views
Something like chainsuck on RD lower pulley after new crankset install?
I just switched out a Shimano M5100 crankset for a SRAM GX Eagle crankset. I am using a KMC X11-EL chain. I cleaned the chain before installing it with the new crankset. My RD is a Shimano SLX 11-...
- 2,090
2
votes
0
answers
96
views
Cable housing end cap for BR-M375
I replaced the no name brake calipers on an entry-level ebike for Shimano BR-M375. The cable housing for the rear caliper was a bit too long, so I cut off a few centimeters. Then, I put a new 5 mm end ...
- 4,159
2
votes
0
answers
364
views
SRAM Guide R bleed problem
I'm bleeding my SRAM Guide R brakes. When working on the rear brake I noticed that the fluid can go from the lever syringe into the caliper syringe, but not the other way around. I can't move the ...
- 6,437
2
votes
0
answers
284
views
after multiple brake bleed, lever's max stiffness is still close to bar
so after a few bleeds i've done on these Shimano saints, because of new levers replacement, i've found that the rear brake lever, although on max stiffness, goes way further to the bar then the other ...
- 185
2
votes
0
answers
177
views
SRAM Hydraulic brake stuck (with a changed bite point) after landing/impact
I experienced a weird problem on my SRAM level t 2 piston brakes.
I like hopping my bike around, e.g. bunny hopping onto curbs. Sometimes, if the impact is hard, the brake lever would have reduced ...
- 121
2
votes
0
answers
207
views
Slight crackling sensation apparently due to the chain sticking to the cassette teeth
I've just assembled my bike, so it has hardly been ridden (less than 200km) and all the components are new.
Everything works perfectly, except an unpleasant very slight crackling sensation when I ...
- 21
2
votes
0
answers
835
views
Why do SRAM rear derailleur not have a parallel movement
My SRAM rear derailleur (Rival 22 circa 2016) has a non parallel movement. When it is in the lowest gear, the cage and pulley sprockets align with the cassette sprockets, but when it's in the highest ...
2
votes
0
answers
161
views
What kind of frame and brakes are these?
I just bought a bike and I can't figure out what kind of frame and brakes it has.
I found that the derailleurs were made by DNB Japan somewhere around 1960 and that the handlebar is french (Guidonn ...
- 128k
2
votes
0
answers
3k
views
Shimano Nexus 3 coaster brake screeching sound
When I brake hard/er with my Shimano Nexus 3 coaster brake it makes a loud screeching sound. Like really loud, everybody on the street would hear it and turn around. Since I know it's all internal all ...
- 352