Unanswered Questions
65 questions with no upvoted or accepted answers
6
votes
0
answers
109
views
What is forward drag on a coaster brake
I have a single-gear coaster brake bicycle that needed fixing. I would have to pedal real hard to get it to go and backpedal a block in advance for bike to stop. Very spongy brakes. Well I took brake ...
- 13.9k
4
votes
0
answers
125
views
Scott 965 hub Problem
Good afternoon, I recently bought a Scott 965, I chose this bike for the beauty of it and the equipment it came with, I wanted to change to a bike with sealed bearings and leave the bearings Sphere ...
CommunityBot
- 1
3
votes
0
answers
141
views
New hub slipping when powering up?
I recently had my Giant Propel SLR serviced (including new chain, Cassette and a new Hub) as gears were beginning to slip. However after the service when I climb into top / hardest gear and put the ...
3
votes
0
answers
599
views
Help identifying a Bianchi track frame
I've been trying to identify this Bianchi track frame - any help would be appreciated! Closest I've come is Eco Pista from early 80s, but I'm absolutely no expert on the matter.
The numbers on the BB ...
- 31
2
votes
0
answers
46
views
Why have my rim brakes started making a scraping noise?
I bought a bike about 7 months ago, and I've noticed over the last few weeks that it's started making an unpleasant scraping noise when I brake. Does anyone know what might be causing this and how to ...
- 121
2
votes
1
answer
74
views
Sram/Avid brake hose compatiblity
I have Sram Rival AXS which I want to transfer from one bike to another. Unfortunately the new bike is bigger (M -> XL) so new brake hose is required. SRAM recommends SRAM Brake Hose Kit - Double ...
CommunityBot
- 1
2
votes
0
answers
96
views
Cable housing end cap for BR-M375
I replaced the no name brake calipers on an entry-level ebike for Shimano BR-M375. The cable housing for the rear caliper was a bit too long, so I cut off a few centimeters. Then, I put a new 5 mm end ...
- 4,159
2
votes
0
answers
284
views
after multiple brake bleed, lever's max stiffness is still close to bar
so after a few bleeds i've done on these Shimano saints, because of new levers replacement, i've found that the rear brake lever, although on max stiffness, goes way further to the bar then the other ...
- 185
2
votes
0
answers
177
views
SRAM Hydraulic brake stuck (with a changed bite point) after landing/impact
I experienced a weird problem on my SRAM level t 2 piston brakes.
I like hopping my bike around, e.g. bunny hopping onto curbs. Sometimes, if the impact is hard, the brake lever would have reduced ...
- 121
2
votes
0
answers
1k
views
DT Swiss 370 hub not spinning smoothly in thru axle frame (end caps?)
I have a brand new rear wheel that uses a DT Swiss 370 hub. (From what I understand, the 370 is the same as the 350 except with pawls instead of a ratchet.) I'm trying to use it on a 12x142 thru axle ...
- 264
2
votes
0
answers
170
views
What does the brake adjuster nut do? Sturmey Archer S2C coaster brake hub
Looking at the schematics of the sturmey archer S2C hub I noticed this part:
2 HMN425 Brake Adjuster Nut (Xylan)
And I was wondering, what does it exactly adjust? Does it adjust the brake ...
- 121
2
votes
0
answers
161
views
What kind of frame and brakes are these?
I just bought a bike and I can't figure out what kind of frame and brakes it has.
I found that the derailleurs were made by DNB Japan somewhere around 1960 and that the handlebar is french (Guidonn ...
- 128k
2
votes
0
answers
3k
views
Shimano Nexus 3 coaster brake screeching sound
When I brake hard/er with my Shimano Nexus 3 coaster brake it makes a loud screeching sound. Like really loud, everybody on the street would hear it and turn around. Since I know it's all internal all ...
- 352
2
votes
0
answers
707
views
Internal Roller Brake Problem
I have Shimano Inter M Roller Brakes on my bike. I felt the rear brakes were a bit light after riding 800 or so KM (total mileage on my bike so far) so I thought maybe theres a bit of cable stretch ...
- 115
2
votes
1
answer
174
views
Front Mountain Bike Cable Disk Brake Is Too Snappy on First Pull
When I grab my front disk brake for the first time on a ride after my bike has sat for a while it will buck me forward. Once it bucks me it works great. I have tried cleaning it with disc brake ...
