All Questions
5
questions
1
vote
0
answers
568
views
Shimano 105 r7000 front derailleur hard and clunky shifting, shifter harder to shift
A total newbie to DIY bike repair here, and my Shimano 105 r7000 FD is shifting really harshly after a wash. Washed it with dish soap plus water solution, however I did not give the FD any specific ...
- 11
0
votes
2
answers
122
views
My chain tool left a divot on my replacement pin. Is this normal?
I recently did a deep clean of my shimano 8 speed road bike chain by removing it from the bike. I used a chain tool to push out one of the pins (not the black one). I then replaced it with a 8 speed ...
- 21
2
votes
3
answers
1k
views
Keeping a 2006 Giant SCR 3 on the road - 9 speed to 11 speed?
I have a Giant SCR 3 which was a freebie from a mate, who had it new. It's approx a 2006 I think, and I've had it about 5 years. I've spend a relatively small amount along the way at the LBS, ...
- 21
7
votes
1
answer
2k
views
What did I just do? Fluid shot out of my handlebar when pushing my caliper in
I just bought a new road bike with hydraulic disc brakes, using a Shimano Ultegra R8020 Groupset. The pad was rubbing on the rear rotor and it wouldn't recenter when pumping the brake. The brake lever ...
- 276
2
votes
1
answer
4k
views
Shimano Nexus Inter-3 internal gear hub stuck in second gear?
The situation My Shimano Nexus Inter-3 internal gear hub is stuck in second gear (it's a 3-gear hub). When I take the external cable housing apart, I can move the pin that goes inside to change gears, ...
- 121