Questions tagged [motor]
Anything about motorising bikes, with refit kits or as-new. Electric and petrol are the two most common fuels.
26
questions
0
votes
0
answers
36
views
Motor makes a very strong grinding noise under specific conditions
I recently bought an EUENI FXH009, very affordable chinese ebike. I'm very happy with it, it's very nice for the price but there seems to be some kind of problem with the motor.
When accelerating ...
2
votes
1
answer
60
views
Motor sometimes not engaging on a moustach lundi 27.5 with bosch performance line motor
The issue I'm encountering sounds similar to Riese Muller with Bosch performance CX not engaging immediately - but may be slightly different.
In a little more detail:
The bike usually starts fine, but ...
1
vote
2
answers
50
views
My rear dropout notch is 12 mm (roughly 1/2"), am I correct in thinking a 3000 watt rear hub motor axle won't fit?
The bike is a Seattle Micargi stretch
The rear dropout width is roughly 180mm and the rear axle dropout notch was widened to 12-13 mm to accept a thru axle rim with a 12 mm axle. With the notch being ...
0
votes
1
answer
92
views
Can I switch my bike from 28" tires to 26" tires if I am replacing everything?
I am completely stripping my hybrid 28" tire bike. I'm replacing the crank, the rims, and tires. I'm converting it to disc brakes and installing a 4-stroke motor. Am I going to run into problems?
1
vote
0
answers
37
views
Choosing a battery for my motor/controller
I'll keep this concise. While I'm pretty overwhelmed with all the reading I've been doing, I believe I'm close to making a decision and need a sanity check on the following:
I purchased a Bafang ...
1
vote
1
answer
189
views
I have a e bike tricycle. Its butchered. I need a wiring diagram
So I found a Segway trike at the dump. It's all there but it looks like some body tried to turn it into a 48 volt system and I do believe that it was originally a 36volt. My next suspicion is that ...
1
vote
1
answer
149
views
I have a still boxed Viribus 26" rear-wheel ebike kit - I'd like to remove its pre-fitted gear cogs and fit wheel with motor to front forks instead
...the Viribus kit's motor(kit bought via Amazon) is of the slim but wide-diameter kind. My eyes and calipers suggest to me that if the gear cogs are removed the motorised rear wheel axle should quite ...
2
votes
3
answers
2k
views
E-bike motor stopping momentarily during steep climbs
I have a Batavus Zonar 2020 e-bike, Yamaha motor, 10 gear cassette, 5500km of use.
Recently the motor has stopped working momentarily during very steep climbs - it just shuts off for a second then ...
-2
votes
1
answer
142
views
Carrera impel IS1 scooter
customer brought in carrera impel IS1 scooter and its pretty new. Max speed should be 15.5mph at the moment it goes just under 10mph. New motor, new ECU been fitted. Is it something to do with the ...
0
votes
1
answer
214
views
Tricycle conversion kit for 24 inch yita home tricycle
What all do I need to buy? Couldn't afford expensive electric kit.what is a good petrol gas kit?
From https://www.amazon.com/YITAHOME-Tricycle-Shifting-Removable-Shopping/dp/B0BYZS7L47?th=1&psc=1
1
vote
1
answer
380
views
Which mid drive motors use the same frame interface?
One concern with mid drive e-bikes is that if the motor breaks in ten years, probably there is no exact replacement available. But do the manufacturers keep the same interface for their different ...
5
votes
1
answer
462
views
Opening up a geared hub motor
I have a 10 year old eWind Classic, and the hub motor makes horrible noises when under high load. It used to be silent. So I want to replace the planetary gears and bearings.
Printed on the hub motor ...
3
votes
1
answer
80
views
Front hub motor makes clacking noise only when nut tightened
I have a Bafang SWXK2 e-bike front hub motor. It has been use for 7 years, about 10 000 km ridden and has worked well so far. But now it is making a clacking noise.
Symptoms:
Clacking noise ...
25
votes
4
answers
2k
views
What characterizes a future-proof ebike drive system?
Ebikes had their origins in modular drive systems that were assembled by enthusiasts and specialty companies choosing their own motors, batteries, battery controllers, motor controllers, and displays. ...
6
votes
3
answers
524
views
Electric bicycle frequently stops working when slope is too high. Cannot find notice
I use my mom's no-name electric bicycle for my daily commute. It is only 3-4 kilometers but there is a big slope. The bicycle's brand and model is Opus E-MOTION, but I cannot find anything online ...