Timeline for What are the 5V and VIN pins for?
Current License: CC BY-SA 3.0
12 events
| when toggle format | what | by | license | comment | |
|---|---|---|---|---|---|
| Jul 7, 2018 at 20:45 | history | protected | CommunityBot | ||
| Apr 1, 2018 at 21:52 | answer | added | PRATIK WAGH | timeline score: 0 | |
| Mar 16, 2018 at 12:03 | answer | added | nuwan karunarathna | timeline score: 5 | |
| Jan 4, 2017 at 9:09 | comment | added | jediz | There is Feeding power to Arduino: the ultimate guide | |
| Oct 5, 2014 at 16:53 | history | tweeted | twitter.com/#!/StackArduino/status/518806194492682240 | ||
| Oct 4, 2014 at 21:41 | comment | added | Mads Skjern | I measure the 5.07V, by putting the multimeter on the points where the USB connector is soldered to the Arduino. | |
| Oct 4, 2014 at 21:39 | comment | added | Mads Skjern | I put the Nano in a breadboard. And I measure the voltages with a multimeter, which I put in the breadboard right next to the pins from the Arduino. I understand that there can be a voltage drop when there is a load, ie when there is a current. But there is no other load in my setup, than what is inside the Arduino itself. | |
| Oct 4, 2014 at 21:03 | comment | added | BrettFolkins | where and when were you getting those voltages? It could be a drop from measuring with and without other current flowing from USB (if you measured initially without the arduino). There should be a small drop as the USB input power does go across a fuse (F1 on schematic) and a mosfet (T1) before reaching the 5v pin. | |
| Oct 4, 2014 at 20:41 | comment | added | Mads Skjern | It's an Arduino Nano, so no barrel jack. | |
| Oct 4, 2014 at 19:07 | answer | added | BrettFolkins | timeline score: 37 | |
| Oct 4, 2014 at 19:06 | answer | added | Ignacio Vazquez-Abrams | timeline score: 6 | |
| Oct 4, 2014 at 18:26 | history | asked | Mads Skjern | CC BY-SA 3.0 |