All Questions
Tagged with raspberry-pi usb
52
questions
1
vote
0
answers
92
views
How can I sniff a USB connection between a PC and a Thermal printer?
I need to develop a hardware and software solution to intercept the communications between a PC - Thermal receipt printer. The protocol between these two is USB, but i don't have any idea of where to ...
0
votes
1
answer
166
views
Dropped HDD seems to be working fine with Windows, makes clicking noise when connected to Raspberry Pi 5
I dropped my External HDD (WD My Passport 5TB) while unplugging it from my Windows PCs USB port. Drop height was about 1m/3ft and it fell on the floor immediately after USB was disconnected. I'm ...
0
votes
0
answers
74
views
Access network storage from USB-storage-only device
I have an oscilloscope (and microscope) that only provide USB storage of images. Both devices run a custom embedded OS so it is impossible to use a USB wifi dongle with them.
Is there any USB device ...
0
votes
1
answer
5k
views
UsbIP client for Windows without needing to put the whole system in "Test mode"?
I'm trying to connect some devices I've got in another room to my computer so it recognizes them as if they were connected through the USB. The setup I'm using is with a Raspberry Pi 4 (Model B):
...
0
votes
0
answers
223
views
Conbee II on /dev/ttyACM0 on Raspi not found
I've got a new Raspberry Pi 4B running on a SSD, fresh install.
Now I try to setup my Conbee2 stick, it connects, is visible with lsusb and with removing+adding it shows with dmesg, but trying to ...
0
votes
0
answers
85
views
Connecting two computers with MIDI via a USB Host-Host cable?
I am currently looking for a way to connect two computers with MIDI.
I need to connect my Raspberry Pi to my Linux desktop. Are you able to do that with a USB3 Host-to-Host cable? Or is there a ...
0
votes
1
answer
2k
views
Raspberry Pi 4 write speed in kb/s using USB-3 SSD?
TLDR; USB-3 SSD on Raspberry Pi 4 has read speeds of 322KiB/s and write of 108KiB/s, expecting MB/s at least...
I've gone through every forum on this one, using this test:
sudo fio --randrepeat=1 --...
1
vote
1
answer
90
views
Can all USB 3.0 ports on tablets receive video (1080p @ 60fps)?
I want to use my tablet as a monitor for my Raspberry Pi 4. To do this I'm using a AverMedia HDMI to USB C capture card. My old tablet won't accept the video-in signal because it's USB 2.0 (Galaxy Tab ...
1
vote
0
answers
863
views
changing device and vendor id of Digispark Digikey
i saw a tutorial on null-byte on how to change the vendor id of a Digikey so that it could be programmed on macOS.
I'm on mac so I'm using my raspberry pi to program the usb. the tutorial said to go ...
3
votes
1
answer
126
views
Connect 3 subnets together
I'm trying to connect 3 subnets on 3 different NIC's together.
In the schematic below I tried to show the connection diagram.
I'm going to connect an android phone via USB to a RPi4 and tether it's 4G/...
1
vote
1
answer
1k
views
How to interface an IR sensor(infrared receiver) with a linux desktop using USB port
I have an IR sensor and I have successfully connected it with RaspberryPI and Ardunio in the past using GPIO pins.
I am thinking of connecting the same sensor(IR sensor) with my Linux desktop using ...
0
votes
0
answers
191
views
How to Connect WeatherlLnk on Raspberry pi 4 using Windows 10 arm?
Recenlty I decided to buy a Raspberry pi 4 model in order to use it as a tiny weather server with
a Davis Weather Station. Unfortunally i was not so familiar with arm architecture and i wanded to
...
0
votes
0
answers
52
views
USB3 needed for RPi based NAS?
I am wanting to build a RPi NAS, following more or less the following instructions: https://magpi.raspberrypi.org/articles/build-a-raspberry-pi-nas
I have the two USB drives (2 TB each), but I only ...
0
votes
2
answers
1k
views
Assign IP address by phsyical USB port
I have a Raspberry Pi with two HUAWEI 4G Wingle E8372 dongles attached.
When I check their MAC address using ifconfig it appears they both have the same MAC address.
I have assigned each dongle a ...
0
votes
1
answer
1k
views
Raspberry Pi seems underpowered, possible damage to external HDD?
I have a Raspberry Pi NAS setup with 2TB external hard drive (internal Hard Drive with enclosure) on it. The main drive is powered by external power adaptor that comes with the enclosure, there has ...